Skip to main content

ALPHATEC® 342 Resin Injection System

ALPHATEC® 342 is a two-component polymer grout injection system consisting of modified epoxy resin and chemical hardener. 

ALPHATEC® 342 is specially formulated for moisture and oil tolerance, and shows exceptionally good bond to wet, submersed, and oil-soaked concrete. It is widely used for the repair of water-soaked concrete foundations for presses, rolling mills, and rails, as well as for the repair of underwater or immersed structural concrete. It also performs well in the repair of all types of rotting machinery foundations, where oil contamination is inevitable.

ALPHATEC® 342 is a product that meets the UNE-EN ISO 179-1 requirements.

Features

Cures within 24 hours at 25ºC
Fills cracks down to 0.02 mm
Good bond to damp or wet concrete
Injectable with HP or LP methods

Packaging and Safety

ALPHATEC® 342 is available in 4.5 and 12 litre sets. In each case the liquid component is packaged in a container which allows for addition of the hardener, and space for mixing. 

For large projects, the product can be packaged in drums; typically a 600 litre set consisting of 2 x 200 litre drums of epoxy liquid, and 1 x 200 litre drum of hardener. 

All ALPHATEC products are intended for industrial use, and should be used only by experienced personnel with proper equipment & training. Always use proper protective clothing, including gloves, face masks or shields, and wash any exposed skin thoroughly after using the product.

Mixing and Handling

Mix the components together using a low-speed electric powered or air-powered mixer for at least one minute. The mixed material can then be poured into the injection pump hopper, and pumped into place. 

If the volume required is small, the product can be measured out into a graduated beaker, using the ratio of two parts liquid to one part hardener by volume. 

When temperatures are very high, it is advisable to use the smaller sets, or to measure out smaller quantities, to avoid premature curing in the container.