ALPHATEC® 110 Fast Curing Epoxy Grout

Download Bulletin AT110

ALPHATEC^® 110 is a three-component polymer grout system consisting of modified epoxy resin, chemical hardener, and blended aggregate. It is especially formulated for rapid curing, and a compressive strength of 60 MPa is attained within four hours when the grout is mixed and cured at 25ºC.

ALPHATEC^® 110 can be used to pour machine support pads for use on the same day, or to provide overnight curing at very low temperatures. It can also work at ambient temperatures as low as 0ºC.

In the last few years, ALPHATEC^® 110 has been used successfully in major refineries and petrochemical plants throughout Europe during winter shutdowns.

Features

Very fast cure at ambient temperatures

Cures at temperatures down to zero

Low shrinkage on cure

Good mechanical properties

Packaging and Safety

ALPHATEC^® 110 pre-measured, and should normally be mixed as a unit.

All ALPHATEC products are intended for industrial use, and should be used only by experienced personnel with proper equipment & training. Always use proper protective clothing, including gloves, face masks or shields, and wash any exposed skin thoroughly after using the product.

Mixing and Handling

Pour full amount of hardener into the pail containing the liquid, and mix for no more than one minute with an air or electric-powered Jiffy mixer operated at low speed.

Pour the mixed resins into a suitable pail of 16 to 20 litre capacity, and add the aggregate portion slowly. Use the full amount of aggregate, unless an Alphatec trained supervisor recommends otherwise. Pour the mixed grout material into the forms without delay.